Schneider Electric / Square D LC1K09105F7 TeSys® K Non-Reversing Contactor; 3 Pole, 9 Amp, 110 Volt AC Coil

Detailed Description: Schneider Electric / Square D TeSys® K 3-Pole Non-reversing miniature contactor is designed for industrial motor control and general duty applications. It is featured with 3 NO auxiliary contact block for extended logic control operations. It is color-coded for easy identification and reduced wiring errors. Increased insulation distances between control and power for full compatibility with installations requiring very low control voltages. It measures 7.930 Inch x 8.390 Inch x 7.990 Inch. It features screw terminal to accommodate 12 - 18 AWG wire connections or solder pins for printed circuit board connections. It is designed to handle inrush power needs of 30 VA. It has a sealed power rating of 4.5 VA to keep the contractor closed. It offers IP 2 terminals protected against direct finger contact. Auxiliary contact block is designed for holding circuit or 4-pole contactor versions. It is mountable on 35mm DIN rail or panel mount with screws for easy installation.

Contactor has an operational voltage of 690 VAC at 50/60 Hz for signaling and power circuit. It has an operational current rating of 9 Amps less than or equal to 440 VAC-3, AC-1 respectively for power circuit and 16 Amps, 20 Amps at 690 VAC, 440 VAC AC-1 for power circuit. Contractor has a motor power rating of 4 kilo-Watts at 500 - 600 VAC, 4 kilo-Watts at 480 VAC, 4 kilo-Watts at 440 VAC, 4 kilo-Watts at 380 - 415 VAC, 2.2 kilo-Watts at 220 - 230 VAC. It has a control circuit voltage of 110 VAC at 50/60 Hz for the closing or opening operation or both of the contactor. It can withstand rated impulse voltage of 8 kilo-Volts which does not cause breakdown under specified conditions test. It can withstand conventional free air thermal current of 10 Amps, 20 Amps at less than or equal to 50 deg C with poles in closed position for signaling and power circuit respectively.

Contractor is designed to store at a temperature of -50 to 80 deg C. It has a electrical durability of 1.3 Mega cycles at 6 Amps AC-3. It has rated insulation voltage of 690 Volts for power and signaling circuit for different standards to meet most of the industrial applications. It operates at minimum switching current of 5 milli-Amps and voltage of 17 Volts for signaling circuit. It has an opening time and closing time of 4 - 19, 12 -22 milli-seconds. It operates at rated breaking capacity of 70 Amps at 660 - 690 Volts, 110 Amp at 220 - 230/380 - 400/415/440 Volts and 80 Amps at 500 Volts for power circuit. It has irms making capacity of 110 Amps for signaling and power circuit. Contractor is UL listed, CSA certified and meets RoHS compliant.